Product Description

Forward Lift Seal Kit / Hydraulic Ram for Forward Hoist / Forward Car Lift Rebuild Kit for 12000 lb 2 post lift models DP12

This is 1 seal kit for the hydraulic cylinders found in forward 2 post lifts model dp12. DP stands for “direct Pull” so these cylinders should hang from the top of the lift and pull up on the carriage that the arm is attached to . This is the 2 cylinder type 12k lift . It meets or exceeds factory specs. This kit rebuilds Prince cylinders that forward used through many years of production. This seal kit will rebuild ONE cylinder if you need to rebuild both cylinders in your lift you will need TWO seal kits.

Fits Forward lift model : DP12 with cylinder number 992322

Replaces Forward  Lift Part: 994293

Alternate Part: 994293, FOD4293

HOW TO IDENTIFY YOUR CYLINDER IS A PRINCE

If your lift has a Prince cylinder in it the cylinder will hang from the top of your lift with a chrome shaft coming out of the bottom of the barrel. Look approximately 8″-10″ below the very top of the cylinder (top of your lift where the bolt goes through the cylinder to anchor it to the lift) see ID stampings. If it reads “Prince” or “AN” followed by numbers this is the proper seal kit for your lift. The gland on a prince cylinder has 2 holes on the face of it for a spanner wrench. It protrudes about an 1/8″ out of the barrel of the cylinder and is flush / even with the barrel outside diameter. Prince cylinders have distinctive black, middle humped seal on the piston. If you are still unsure if this seal kit will work for you, call our help hotline @ 866-902-6060 and we will be glad to determine what seal kit you need.

This kit came in the following model lifts and may fit others as well

• This kit came in the following model lifts and may fit others as well DP12

HOW LONG DOES IT TAKE?

This kit usually takes less than an hour to install and can be done with a vice, pipe wrench and a few hand tools.

WHAT THIS KIT WONT’ FIT!

If you see the letters “AA”, “T” or “TX” followed by #s or your gland is not the same design as the one pictured then your cylinder is not a PRINCE and this seal kit will NOT work with your lift, but we offers those seal kits as well in our related products section below.

RETURN POLICY ON SEAL KITS

Our seal kits come in a sealed clear bag. Warning! Do not open bag until your verify you have the right seal kit once your cylinder is torn down. Simply remove your old seals from your cylinder and match them up by holding them next to new seals in bag. If they appear similar inside and outside diameter then you have the correct seals. If your not sure please call us before opening the bag. We will not except returns from open /used seals because you didn’t verify fitment first. Call us at 866-902-6060 if you have any questions about this product or any other auto equipment questions.

Forward Auto Lift Cylinder Seal kit 994293 2 Post Hydraulic Cylinder Rebuild Seals

See Below for Full Product Description and Fitment Details