Product Description

1x Auto Lift Stop Bar Switch Button Limit Bar Stop Actuator

This is a heavy duty electrical micro switch made for MANY brands of Automotive lift power units. It controls the hydraulic motor and is the Stop button for the limit switch bar or cable for many lifts. This switch prevents vehichles from running through the overhead beam on 2 post lifts and is crucial to prevent damage to the lift or vehichles. It came in many OEM application mounted inside motors housing or on the top of the lift in housing that hold the stop bar on Rotary lift, Forward Lift, Direct Lift, Hanmecson Lift, Challenger Lift, VBM Lift, Whip Lift, Western Lift Worth Lift & many more. It was used in conjunction with motors built by SPX, Fenner Stone, Monarch, Barnes, Doer, Emerson, and used in other brand motors as well. Please see below for OEM part # reference.

ALM Lift -A00242
Ammco®* Lift- 80282
Benwil Lift-300282 , 290037
Challenger Lift- 1258-AA
Fenner -1288AA
Forward Lift -991088 , 991226
Manitowac – c-723-20
Monarch- 0352
MTE- 69210023
Rotary Lift- P461-2, Fj7108-2,
SPX -1258-AA
SVI- bh-7004-19
Western Lift- S707
Wheeltronics Lift- 6-0916

This Switch is rated for 25 amps and is usually found on 208-230vac motors but can also be used on 110v.

It has 3 screw terminals on the back/ bottom of the Micro switch where wires are connected (wires typically only connected to 2 out the 3 terminals). The terminals are usually marked “NO” “NC” “COMMON” or “COM” and the switch can be set up for normally open or normally closed operation.The front of the switch has a metal button/ plunger which is what actuates the switches operation. The plunger goes into a brass colored housing which has threads and nuts allowing the switch to be mounted to limit switch housings. These switches are high quality units meeting all electrical codes and requirements. All our switches have been 10,000 press tested to ensure long life.
Most of the time when these switches fail, they either burn out at the terminal or can stick on and continually run the motor. Your old switch can be tested with a simple continuity test to identify if the switch is the cause of your problems. This switch can be wired Normally open or Normally closed depending on what terminals are used

Overhead Stop Bar Switch / Button for Limit Switch Cable

If you have question about this product or any other equipment question call us at 866-902-6060

 *Ammco®  is registered trademark of Hennessy Industries, Inc. CARLIFTPARTS is not associated in any way with Hennessy Industries, Inc.  All names, numbers, symbols and descriptions are used for reference purposes only.  It is not implied that any part listed is the product of these manufacturers.  The parts we offer are an O.E. alternative; they are not produced by O.E. Manufacturers such as Ammco ®*, Coats®* or similar manufacturers respectively.