This is a NEW set of 2 cables for bendpak 2 post, magnum 2 post and ranger 2 post lifts. These fit the models below with the following specificationsBend pak MX-10ACX cables

Bendpak # 5595515 , 5595510

Possible Alternate Part Number: BH-7479-54

Bendpak lift model MX-10ACXMX-10ACX cables
Ranger Lift Model R2M-10ACW
Magnum Lift Model Mx-10ACX
NOTE: THESE CABLES FIT LIFTS MADE IN 2003 OR LATER AND ARE MADE FOR STANDARD HEIGHT AND WIDTH LIFTS.(BENDPAK LIFTS OFFERED VARIABLE HEIGHTS AND WIDTHS)

PLEASE DOUBLE CHECK THE FOLLOWING CRITERIA BELOW BEFORE ORDERING:
Make sure your lift is made in 2003 or later by locating the data tag on the power unit post of the lift and look at the production date.
Check the height of the columns on your lift , They should measure 12′-1″ (145″)
Check the width between the two columns including the base. Should measure 12′-1″ (145″)
The base foot plate on each column measures 21″ x 21.5″
Make sure the columns are turned facing the rear of the bay and not facing each other
Make sure the lift is truly “Asymetrical” meaning it has a short arm in the front and long arm in the rear on each column
If all Specification match the above information then these cables should fit your lift. If there are any Specs that are different from the above information or you need assistance with the measurements CALL 866-902-6060 

These cables are high quality cables made in the USA which have been pull tested for strength. They will meet or exceed factory specifications.